DELAY COMPENSATION PRO TOOLS MANUAL

Make sure to mute the Console channels corresponding to the line inputs that the return signal from your outboard gear is being fed into to avoid double monitoring.

On the 'Insert' tab, Apollo's MON out uses output pair 1-2, so you have to make this final adjustment to line up your hardware inserts: drag the entire set over one pair so that Insert 1-2 is using I/O 3-4, Insert 3-4 is using I/O 5-6, and so on.

This will re-populate the tab with the correct paths.

Once all paths are deleted, click the 'Default' button.

Repeat these steps for the 'Output', 'Bus' and 'Insert' tabs as well.

Delete all paths on this tab so it is completely empty. On the 'Input' tab, select all paths shown and click 'Delete Path'.Next, navigate to Setup > I/O and click on the 'Input' tab when the I/O Settings window appears.To do this, open Pro Tools and navigate to Setup > Playback Engine and make sure 'Universal Audio Apollo' is selected. You will first need to make sure that the Apollo is selected as your Playback Engine within Pro Tools.Selecting an I/O Preset Pro Tools I/O SetupДЇollow the directions below to reset your Pro Tools I/O: Once you have selected the appropriate I/O preset for your system, please choose LOAD, and proceed to resetting the Pro Tools I/O as described below. For example, if youвЂ™re using a single Apollo x8p, select the вЂњSingle-Apollo x8p PT вЂќ preset from the I/O Presets menu. You can select one of the I/O presets already available that matches your configuration which will align your line inputs and outputs automatically. In order for the channels numbers to correspond, we must insert вЂњnullвЂќ values for the first 2 inputs so that Mic/Line/Hi-Z 1 lines up with Line Output 1, Mic/Line/Hi-Z 2 lines up with Line Output 2, and so on. In the default Apollo I/O setup, the first two input channels are Mic/Line/Hi-Z 1 & Mic/Line/Hi-Z 2, however the first two output channels are Monitor L and Monitor R. The Pro Tools Hardware Inserts feature requires that you connect your external gear on the same input and output channels of your Apollo interface, i.e., Line Inputs 1-2 and Line Outputs 1-2. In order to use the вЂњHardware InsertsвЂќ feature in Pro Tools, you will first need to change the default I/O setup on the IO Matrix page of Console Settings (Console > Settings > IO Matrix).

DELAY COMPENSATION PRO TOOLS MANUAL

For more information, see the 'PT Mode' section in the 'Working With Apollo' chapter of the Apo llo Software Manual (FireWire). If using an Apollo silver or Apollo 16 via FireWire, use the 'PT Mode' option (Console > Settings > Hardware) to configure the I/O for hardware inserts.If using an Apollo Twin, see the Using Hardware Inserts with Apollo Twin article. This article covers configuring the I/O of rackmount Thunderbolt Apollo interfaces (Apollo silver w/ TB option card, Apollo 8, Apollo 8p, Apollo 16 w/ TB option card, Apollo 16 mkII, Apollo ењ†, Apollo x8, Apollo x8p, Apollo x16) in order to use Hardware Inserts in Pro Tools.

Delay compensation pro tools